Important:
This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist.
A version of this page is also available for
4/8/2010

Resets the end-of-stream flag.

Syntax

virtual HRESULT ResetEndOfStream(void);

Parameters

None.

Return Value

Returns an HRESULTvalue.

Remarks

This member function is typically called when changing to stopped states.

A renderer must keep track of when it gets told that no more data will arrive (this is done when the sourcing filter calls IPin::EndOfStream). At this point the renderer finishes rendering data it has and sends an EC_COMPLETE event to the filter graph manager.

However, when the filter is stopped, the whole state is cleared. When the filter is subsequently run, the source filter signals the end of stream again if it has no data to send.

In this case, the renderer should signal another EC_COMPLETE event to the filter graph manager.

This member function resets the state so that when next requested it will send an EC_COMPLETE event.

Requirements

Windows Embedded CE Windows CE 2.12 and later
Windows Mobile Windows Mobile Version 5.0 and later
Note Microsoft DirectShow applications and DirectShow filters have different include file and Library requirements
For more information, see Setting Up the Build Environment,
Version 2.12 requires DXPAK 1.0 or later